How can I enable PASV mode?

How can I enable PASV mode?




In the Administration console, under your server, go to the Connections category. On the Connections Advanced tab you will see a check box that reads "Allow PASV mode connections". Make sure this box is checked.



    • Related Articles

    • What is the difference between Active (PORT) mode and Passive (PASV) mode?

      Active (PORT) mode: In active (port) mode the FTP client specifies the data port that the FTP server is going to connect on and waits for the FTP server to connect. The IP address and port number are sent to the FTP server by the FTP client using the ...
    • Literal pasv command not working

      Problem: My server is behind a firewall. When I try the "literal pasv" command, the connection times out. What could I be doing wrong? Solution: The 'literal' command in the command line FTP utility is used to blindly pass the command to the server; ...
    • Changing Authentication Mode for SQL

      To change the authentication mode from Windows NT Authentication Mode (only) to Mixed Mode, use the following steps:  Open the Enterprise Manager.  Expand a Server group.  Right-click a server name, and then click Properties.  Click the Security ...
    • Changing Authentication Mode for SQL

      To change the authentication mode from Windows NT Authentication Mode (only) to Mixed Mode, use the following steps: Open the Enterprise Manager.  Expand a Server group.  Right-click a server name, and then click Properties.  Click the Security tab.  ...
    • Do I have to enable FTP in order to use the WebUI?

      Question: Do I have to enable FTP in order to use the WebUI? Answer: No, you do not have enable FTP to use the Webui.